BULLY DOG TECHNOLOGIES
UNCOMPROMISED DIESEL PERFORMANCE
RAPID FLOW INDUCTION SYSTEM
'03-UP 6.0L FORD POWERSTROKE DIESEL P/N# 221104
Bill of Materials:
1 RFI Conical Filter
1 RFI Intake Box
1 T20 Torx Bit 		Tools you need:
flat headed screw-driver
T20 Tamper Proof Torx Bit(included) 		Avaiable accessories:
Filter Cleaning Kit
Filter Wrap
To order these call: 1-800-697-0194
Installation of Bully Dog Rapid Flow Induction System
  1. Remove the clips from the front and rear of the airbox/filter.
  2. Pull out the air feed-tube that runs into the front of the airbox/filter
  3. Pull out the stock airbox/filter this may be a little difficult and require some elbow grease.
  4. Remove the hose clamp that holds the upper part of the airbox to the rubber turbo inlet pipe.
  5. Remove the mass air flow sensor using the supplied T20 Tamper Proof Torx bit.
  6. Install the new RFI Air-Box onto the Turbo inlet pipe. And make sure that the locating pins slip through the air-box holder.
  7. Install the mass air flow sensor into the new RFI Air-Box using the same screws that were removed from the stock box.
  8. Install the Air Filter onto the new RFI airbox. And tighten the hose clamp.
  9. Check and tighten all fasteners and be careful to look for any loose parts
  10. Test drive the vehicle being careful to listen for any strange noises
  11. The installation of the Bully Dog Rapid Flow Induction system is now complete. Picture 3

Picture 1


Picture 2