Bully Dog Transmission Gauge
Installation Instructions
Read the disclaimer
before continuing with installation
- The gauge may be mounted in a 2 1/16” hole in the dash, a
gauge panel or a pod mount made specifically for you vehicle.
- Attach gauge wiring before mounting gauge into hole.
- Install sending unit in transmission (either in port in
transmission housing or tapped into oil pan).
- Connect the negative (-) post on rear of gauge to a good
ground. Connect positive (+) post on rear of gauge to ignition on
power. Connect S post on rear of gauge to sending unit.
- Plug in light assembly and connect as per step 7 above.
|
|
